xyin — Sense the cursor position in an output window


Sense the cursor position in an output window. When xyin is called the position of the mouse within the output window is used to reply to the request. This simple mechanism does mean that only one xyin can be used accurately at once. The position of the mouse is reported in the output window.


kx, ky xyin iprd, ixmin, ixmax, iymin, iymax [, ixinit] [, iyinit]


iprd -- period of cursor sensing (in seconds). Typically .1 seconds.

xmin, xmax, ymin, ymax -- edge values for the x-y coordinates of a cursor in the input window.

ixinit, iyinit (optional) -- initial x-y coordinates reported; the default values are 0,0. If these values are not within the given min-max range, they will be coerced into that range.


xyin samples the cursor x-y position in an input window every iprd seconds. Output values are repeated (not interpolated) at the k-rate, and remain fixed until a new change is registered in the window. There may be any number of input windows. This unit is useful for real-time control, but continuous motion should be avoided if iprd is unusually small.

[Note] Note

Depending on your platform and distribution, you might need to enable displays using the --displays command line flag.


Here is an example of the xyin opcode. It uses the file xyin.csd.

Example 1260. Example of the xyin opcode.

See the sections Real-time Audio and Command Line Flags for more information on using command line flags.

; Select audio/midi flags here according to platform
; Audio out   Audio in    No messages
-odac           -iadc     --displays ;;;RT audio I/O
; For Non-realtime ouput leave only the line below:
; -o xyin.wav -W ;;; for file output any platform

; Initialize the global variables.
sr = 44100
ksmps = 10
nchnls = 2

; Instrument #1.
instr 1
  ; Print and capture values every 0.1 seconds.
  iprd = 0.1
  ; The x values are from 1 to 30.
  ixmin = 1
  ixmax = 30
  ; The y values are from 1 to 30.
  iymin = 1
  iymax = 30
  ; The initial values for X and Y are both 15.
  ixinit = 15
  iyinit = 15

  ; Get the values kx and ky using the xyin opcode.
  kx, ky xyin iprd, ixmin, ixmax, iymin, iymax, ixinit, iyinit

  ; Print out the values of kx and ky.
  printks "kx=%f, ky=%f\\n", iprd, kx, ky

  ; Play an oscillator, use the x values for amplitude and
  ; the y values for frequency.
  kamp = kx * 1000
  kcps = ky * 220
  a1 poscil kamp, kcps, 1

  outs a1, a1


; Table #1, a sine wave.
f 1 0 16384 10 1

; Play Instrument #1 for 30 seconds.
i 1 0 30


As the values of kx and ky change, they will be printed out like this:

kx=8.612036, ky=22.677933
kx=10.765685, ky=15.644135

See also

Sensing and Control: Keyboard and mouse sensing


Example written by Kevin Conder.