lposcilsa — Read stereo sampled sound from a table with looping and high precision.
ar1, ar2 -- output signal
aamp -- amplitude
kfreqratio -- multiply factor of table frequency (for example: 1 = original frequency, 1.5 = a fifth up , .5 = an octave down)
kloop -- start loop point (in samples)
kend -- end loop point (in samples)
lposcilsa is the same as lposcila, but works with stereo files loaded with GEN01.
Here is an example of the lposcilsa opcode. It uses the file lposcilsa.csd.
Example 556. Example of the lposcilsa opcode.
See the sections Real-time Audio and Command Line Flags for more information on using command line flags.
<CsoundSynthesizer> <CsOptions> ; Select audio/midi flags here according to platform -odac ;;;realtime audio out ;-iadc ;;;uncomment -iadc if realtime audio input is needed too ; For Non-realtime ouput leave only the line below: ; -o lposcilsa.wav -W ;;; for file output any platform </CsOptions> <CsInstruments> ; additions by Menno Knevel 2022 sr = 44100 ksmps = 32 nchnls = 2 0dbfs = 1 instr 1 kcps = 1.3 ;a 3th up kloop = 0 ;loop start time in samples kend = p4 ;loop end time in samples aenv expsega 0.01, 0.1, .8, 1, .3, 1.1, .42 ;envelope with fast and short segment aL, aR lposcilsa aenv, kcps, kloop, kend, 1 ;use it for amplitude outs aL, aR endin </CsInstruments> <CsScore> ; table size of stereo file is deferred, ; and format taken from the soundfile header. f 1 0 0 1 "drumsSlp.wav" 0 0 0 i 1 0 5 45000 i 1 6 3 15000 e </CsScore> </CsoundSynthesizer>